WorkZone actions
The table below lists the actions that the Interact connector service workflow can perform in WorkZone based on data that is retrieved from Interact forms. The Interact connector service workflow supports:
- Creating new cases
- Updating existing cases
In both scenarios, information from the Interact form is inserted into the corresponding fields on the case. If documents are attached to the Interact form, they are added to the case. In addition, two system generated documents are always added to the case:
- A PDF document—A user-friendly representation of what the user submitted through the Interact form.
- An XML document—This is the corresponding technical document, which contains the same content and additional meta data about the submitted data. This document is added as a supplementary document to the PDF document.
The table below provides an overview of the actions that the Interact connector service workflow supports.
Action | What happens? |
---|---|
Insert data from fields |
Data from the Interact form is inserted into the corresponding fields on the case, attached documents, and to new contacts that are added. This action applies to both standard and custom fields on cases, but only standard fields are supported on documents and contacts. |
Add documents |
Documents that are attached to the Interact form are added to the case. The documents are created with the document title that the user has specified in the form. The title will be applied to all attached documents. If the title is not specified, the file names of the attached documents will be used as document titles. |
Add a new contact |
If the contact does not exist in WorkZone, a new contact is created and assigned as a party on the case. The party will be assigned the role Case party (Sagspart) by default. It is not possible to change the configuration of the default role. The contact is created based on the type that the user has specified in the Interact form, for example persons with CPR or companies with CVR. Note that if you see the following error message: "Failed to construct OData Entities. Check OData property names. (Custom label Sagspart with the type equal to SP does not exist in the database.)" It means that the Case party role that was assigned has an end date. You must remove the end date to solve the issue. |
Add a contact as a party on a case |
If a contact already exists in WorkZone, the contact is added as a party on the case. Existing contacts are identified on the basis of the NameCode and NameType fields. This means that these fields must be mandatory in the Interact form. Note: In this release, parties cannot be removed from the case.
|
Update an existing case |
If a user submits an Interact form that contains a file key (FileKey or FileNo) that exists in WorkZone, the following happens:
|