Configure Serverscan

The prerequisite for this description is that the relevant plug-in assemblies have already been imported.

All path descriptions are suggestions. You can change them in the actual configuration.

  1. Click Operation > Service Channels. The Service Channels module displays.
  2. Click in the first data cell in an empty row in the upper right panel - Channel definitions for ScanJour Services and enter the following values:

Column

Enter this value

Channel Number

2

Service Number

2

Description

Serverscan

Scan Intervals

1

Enabled

Click in the check box to enable the current channel.

Watch Class

Select Scanjour.Services.DirectoryWatch in the drop-down box.

Data Consumer Class

Select Scanjour.Services.XdiDataConsumer in the drop-down box.

Error Path

Enter the following path: C:\ServiceError\Channel 2
  1. Place the cursor in another cell and click Database > Save.
    The information has been saved.
  2. Click the left most cell of the row you just saved - the cell to the left of Channel Number. Now the bottom right panel is activated. You can register information about plugin parameters here - the panel is named Plugin settings for channel 2.
  3. Enter the following values:

Column

Enter this value

DirectoryWatch monitored folder

C:\XDIPORT

Direct oryWatch Folder mask

*.xdi

XdiDataConsumer XMLscheme folder

C:\Program Files (x86)\KMD\WorkZone\Program\XDIData

  1. Place the cursor in another cell and click Database > Save.


Installing and starting the service

In the lower left panel you can now install and start the service. The service must be started as Local System.